P0013 Code- Intake Camshaft Position 'B' Actuator Circuit Open Bank 1

What Does Code P0013 Mean

P0013 is the OBD-II generic code indicating that the engine control module (ECM) has determined that the bank 1 exhaust camshaft OCV has an open or short circuit.

engine code P0013	P0013 fix	obd P0013	dtc P0013
obd code P0013	obd2 P0013	P0013 car code	diagnostic code P0013
car code P0013	check engine code P0013	fehlercode P0013	P0013 fiat
codigo P0013	codigo falla P0013	P0013 kody błędów	codigo de falla P0013

Possible symptoms

• Engine Light ON (or Service Engine Soon Warning Light)

Possible causes

• Bank 1 Camshaft 2 Position Actuator circuit is open or shorted
• Bank 1 Camshaft 2 Position Actuator circuit poor electrical connection
• Faulty Camshaft position solenoid
• Faulty Powertrain Control Module (PCM)

Troubleshooting P0013

Troubleshooting Code P0013 involves a circuit check, and all diagnostic procedures must therefore include inspecting, and testing the wiring harness and control solenoid. The circuitry is relatively simple, consisting for the most part of a 12 volt DC power supply to the oil flow control valve, a ground pin to which the ECM supplies a ground at the correct time and in the correct amount, and a feedback loop to the ECM to confirm functionality.

Basic trouble shooting steps

• With the engine off, check the electrical connector on the oil flow control valve for signs of damage, looseness, and/or corrosion. Clean, replace, or repair connector as required.

• Check for continuity in the wiring at the oil flow control valve. If continuity is interrupted, inspect wiring to trace breaks, and/or poor connections, and repair as required.

• Check oil flow control valve solenoid resistance, and compare results with the value specified i the repair manual. Replace solenoid if resistance is out of spec.

• With the engine off, remove the oil flow control valve solenoid, and apply power directly from the battery, but ensure a sound ground connection is made. Replace the solenoid if a direct power supply fails to activate the solenoid.

• If a direct connection activates the solenoid, replace the solenoid, and inspect the wiring between the solenoid and the ECM for short circuits, open circuits, or high resistance. Repair as required.

• If all wiring checks out OK, use a suitable scan tool to check the functioning of the oil flow control solenoid and valve. The valve should be closed during idling, but higher engine speeds will activate it. Check the status of the valve through the rev range of the engine to see if it changes from “OFF”, to “ON” as the engine speed changes. Replace the solenoid/valve if the status does not change.

• In cases where the pulse width of the oil flow control valve is modulated, the active duty cycle should vary with engine speed. If this does not happen, the cause is almost certainly due to a defect or malfunction in the ECM.

• In cases where the ECM delivers valid commands to the oil flow control valve, but the cam/valve timing does not return to the base timing, or where the cam phaser does not advance/retard timing sufficiently or correctly, there may be an intermittent fault in the control solenoid, or in the associated wiring. In these cases, it is advisable to replace both the oil flow control solenoid, and the entire harness that controls it. If the fault persists, have the ECM tested if possible, or replace the ECM.

Searches related to P0013

p0013 chevy equinox
p0013 cobalt
p0013 pontiac g6
p0014 code
p0013 chevrolet malibu 2013
p0014 chevy malibu
exhaust camshaft position actuator
p0013 saturn aura